Request a Quote ↗
← Application Areas

Valve Planning for Tap Water Supply Systems

A tap-water supply system carries treated water from a plant or storage facility through transmission lines and distribution branches to customers.

Tap Water Supply

A tap-water supply system carries treated water from a plant or storage facility through transmission lines and distribution branches to customers. Valves allow operators to change the route of flow, isolate a main break, and maintain equipment while limiting the number of customers affected. Their value is most visible during an emergency, when a buried or seldom-used valve must still work.

Plan the network in workable zones

Isolation points should reflect the network layout as well as any applicable valve-spacing, access, and utility requirements; a fixed interval alone is not a complete placement strategy. Major junctions, storage connections, pressure-zone boundaries, and critical customers all influence where valves are placed. Large mains may use butterfly valves where the project specification permits; smaller connections can use other arrangements. Pump discharge, backflow prevention, pressure regulation, and air release are separate functions that need their own devices and hydraulic review. Closing a valve too quickly can create pressure transients, so operating procedures matter as well as the hardware.

Protect water quality

The assembled valve and its wetted materials should meet the applicable drinking-water requirements. Verify any required certification or approval for the exact model, size, material configuration, and conditions of use; a general product-family description is not enough. Pressure management is also a water-quality issue. Low or negative pressure can permit contaminant intrusion where a leak or other entry path exists and the external pressure exceeds the pressure inside the pipe. Excessive pressure and transients can contribute to leaks and main breaks. Valve location and operation should therefore be coordinated with pumps, storage levels, monitoring points, and pressure-zone controls.

Design for the people who operate it

Record every valve's location, turn direction, normal position, and number of turns or travel angle. Provide access boxes or chambers suited to local conditions. A routine exercise and inspection program helps identify valves that are difficult to turn, leak past the seat, or cannot be found when a repair is needed.

Pango can compare available valve configurations with a project valve schedule after pressure class, connection, materials, and required drinking-water approvals are confirmed.